Table of Contents
Advertisement
Using the Remote C+ntro
If the component
you want to control
does turn off:
1. Press and release REVERSE,then wait 2 seconds. Repeat this step until the
component
turns back ON.
2. To finish, press and hold STOP until the indicator
on the remote turns off.
Using Direct Entry
1. Turn on the component
to be programmed.
2.
Look up the brand and code number(s) for the component
on the code list in
this section.
3.
Press and hold the component
button you want to program on the remote.
4.
Enter the 4-digit
code from the remote control code list on the following
pages, if the indicator
flashes, you have either entered an invalid code or the
button
isn't programmable.
5.
Release the component
button.
6.
Point the remote at the component+ Press ON°OFF to see if the component
responds to the command. If it doesn't, try pressing the component
button
and
then ONoOFF again.
•
If you get no response, repeat these steps using the next code listed for your
brand, until the component
responds to the remote commands.
•
If you try all the codes for your component
brand and none work, try the
automatic
code search method. If automatic
code search doesn't find the code,
the remote is not compatible
with your component.
How to Use the Remote After
You've Programmed
It
Because this universal remote can control several different
components
(W, DVD,
VCR, satellite receiver, etc.) it uses operational
modes triggered
by the component
buttons. For example, if you want the remote to control the W, you would press
the W button to put the remote into _[V mode before you could control the W.
1. Press the appropriate
component
button (DVD, W, VCR1, VCR2, SAToCABLE,
AUX] to set the remote to control the component.
2.
Press ONoOFF to turn the component
ON or OFF.
3.
Use the remote buttons that apply to that component.
Note:If you keeppressingbuttons end nothing happens, the remote isprobably in the wrong
mode.Youmust pressthe component button that matches the eomponent you wont to
operate(i.e.,if you went to operete the VCR, p ress VCR 1on the remote control to put the
remote in VCR mode.)
14
Graphics contained
within this publication
ore for representation
only
Chapter 2
Advertisement
Table of Contents
