Table of Contents
Advertisement
PROGRAMMING
THE
REMOTE
TO CONTROL
OTHER
DEVICES
The AUX button is a device button that can be programmed to
control a second VCR, a cable box, or a laserdisc player.
1.
Turn on the device to be programmed.
2.
Look up your brand and its code number on code list on the
following pages.
3.
Pressand hold the AUX button.
4.
Enter the three-digit code from the code list.
6.
Release the AUX button and press POWER or CHAN UP/DOWN
to see if the device responds to the remote commands.
7.
Repeat these steps using the next code listed for your brand
until the device responds to the remote commands.
This remote
may not operate
all
models of the brands that are
shown.
Use the codes shown
in
this manual,
or on the sheet
packed with your remote.
After you program
the remote
to
control
a device,
record
your AUX
code here for easy reference.
000
USING
THE
REMOTE
BUTTONS
TO CONTROL
A
DEVICE
Once the remote has been programmed with the correct codes,
you are ready to use it to control your devices.
To operate the device:
1.
Pressthe device button (TV, DSS1, DSS2, VCR, or AUX) to set
the remote to control the device.
2.
Press POWER to turn the device off or on.
3.
Use the remote buttons that apply to that device.
Advertisement
Table of Contents
