Table of Contents
Advertisement
WARNING
To reduce risk of fire or
shock hazard, do not
expose this receiver to
rain or moisture.
TO REDUCE THE RISK OF ELECTRICSHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER SERVICEABLEPARTS INSIDE.
REFERSERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol indicates
"dangerous
voltage" inside the
product that presents a risk of
electric shock or personal injury.
This symbol indicates
important
instructions
accompanying the product.
Cautions
Note to Cable TV Installer:
Note to Satellite
Dish Installer:
IMPORTANT NOTICE:
Care and Cleaning:
Do not stack electronic
components
or other objects
on top of
the DSS* Receiver. The slots on top of the receiver must be left
uncovered to allow proper airflow to the unit. Blocking the airflow to
the unit could impair performance
or damage your receiver and other
components.
Do not stack the DSS ° receiver on top of a "hot component" such as an
audio power amplifier.
FCC Regulations state that unauthorized changes or modifications to
this equipment
may void the user's authority to operate it.
The RF remote control complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: 1) The RF remote
control may not cause harmful interference and; 2) The RF remote
control must accept any interference received, including interference
that may cause undesired operation.
This reminder is provided to call your attention to Article 820-40 of the
National Electrical Code (Section 54 of the Canadian Electrical Code,
Part 1) which provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be connected to the
grounding system of the building as close to the point of cable entry as
practical.
This reminder
is provided to call your attention
to Article 810 and in
particular article 810-15 of the National Electrical Code which covers
proper installation and grounding of television receiving equipment
as
well as to article 820-40 of the National Electrical Code which specifies
that the satellite dish cable ground shall be connected to the
grounding system of the building as close to the point of cable entry as
practical.
This device incorporates
an anticopy process technology
that is
protected by U.S. patents anc_other intellectual property rights. The
anticopy process is licensed for non-€ommerical, home use only. Reverse
engineering
or disassembly is prohibited.
Use a soft cloth or dusting attachment ofyQur yacuu.m cleaner to dust
your DSS® receiver. Remove dust from the ventilation holes on the top
and bottom.
Plastic surfaces are easily scratched and can be marred by alcohol and
various solvents. Avoid excessive use of oil-based furniture polishes
since the materials used in the cabinet will accumulate more dust. A
non-abrasive, anti-static cleaner/polisher is recommended.
Advertisement
Table of Contents
