Table of Contents
Advertisement
C@nnecti@ns
Setup
Things to Consider Before You Connect
Protect Against
Power
Surges
•
Connect all components
belore you plug any of their power cords into the wall out|et.
•
Turn off the TV and/or component
betk)re you connect or disconnect
any cables.
•
Make sure all antennas
and cables are properly grounded.
Reter to the Important
Saleguards
sheet packed
with your TV.
Protect
Components
from
Overheating
•
Don't block ventilation
holes on any ot the components.
Arrange the components
so that
air can circulate t_ceely.
•
Don't stack components.
•
When you place components
in a stand, make sure you allow adequate
ventilation.
•
If you connect an audio receiver or amplifier, place it on the top shelf so the heated air
IF(sill it won't flow around other components.
Position
Cables Properly
to Avoid
Audio
Interference
•
Insurt each cable firlnly into the designated
jack,
•
If you place components
abo_ e the T_,, route all cables down the side of the back ot the
TX, instead ot straight down the middle <51 the back ot the TV.
•
I1 your antenna
uses 30(}-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away trom audio/video
cables.
Important
Stand and Base Safety
Information
Choose the location tor your TV c'aret_llly. Place the TV on a stand or bas_,/hat is ot adequate
size and strength to prevent the TV flcom being accidentally
tipped over, pushed
<5t"1, or pulled
off. This could cause personal
injury and/or damage the TV. Ret_,r to the hnportant
Sat_,guards
sheet packed with your TV.
Use Indirect Light
Don't place the TV where sunlight or room lighting will be directed toward the screen. Use soft
or indirect lighting.
Demo
Pin
)
You must remove the 1-)emo t in t_comthe G-LINK jack on the back of
your TV in order Iksr your TV to operate
properly and to connect the
G-LINK cable.
6
Chapter
I
Advertisement
Table of Contents
