Table of Contents
Advertisement
C@nnecti@ns
Setup
Step 3: Configuring
for a VCR
1.
If your TV is connected
to a VCR, press OK.
If it is not, highlight No and press OK (a screen appears
reminding
you to
connect your G-LINK cable to your "1"\ 7and VCP,).
2.
Use the up and down arrow buttons to highlight the brand of your VCR that
is connected
to the TV.
If: your brand isn't listed, highlight NOt Listed and press OK.
3_
Tune your VCR to channel 02. Next, turn OFF your VCt{. When you
complete
these steps, press OK to begin testing,
Important
Note:
When code te.;ting i._in pro,gre.;s, do_ 't toz_ch yoz_r 7'_
VCR, or a_zy q/'t,Se remote controtsjbr
t,Sese products.
f
Look at the front display of your VCR. If your _,Ct{ turned on automatically
and changed
to channel 09, the test was successful.
Highlight
Yes"and press
OK,
If your VCR didn't change to channel 09, you can either choose NO or 7bst
this code a_,_ain.
If you think your TV or remotes might have been touched
during tile test,
7
•
tune your VCP, to channel
02, turn ofl your \ CP, and highlight
7}<vt t his
code again.
If you don't think the test ,.,*,asinterrupted,
highlight NO, Tune your VCR to
channel 02 and turn off your VCP,. Press OK (the GUIDE Plus+ system starts
testing another set of codes.)
Keep lk)llowing tile previous
instructions
until the VCR tinds the correct
code.
18
Chapter
I
Advertisement
Table of Contents
