Advertisement
Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels
2-13 appear in the TV's memory
when you first turn it on.
The channels
available
in your area must be programmed
into the TV's
memory
when you hook up your TV. Using CHANNEL up or down
allows you to scan through
these channels.
You may want to add or delete a few channels
if some stations
have weak
signals or were off the air when the TV was programmed.
Refer to the Add
or Delete Channels section below.
1.
Place channels
in
memory
(AutoProgram)
Controls
Alarm Ad
13
h.
B.
Hook up an antenna,
cable or
components
before you begin
these steps or you will not be
able to add channels
into
memory.
Press MENUopROG repeatedly
to select the Setup Menu and
highlight
Autoprogram.
This
menu is white.
C. Press MOVE • (down) to
highlight
Autoprogram.
D. Press MOVE • to start the TV
adding all active channels into
memory.
E. Wait until the TV has cycled
through all the channels and
returns
to the original channel.
2. Add or delete
channels
Controls
Alarm
Ad
;ontrols Alarm
Ad
13
13
A,
Press MENU,PROG
repeatedly
to select the Setup menu.
This
menu is white.
B. Press MOVE • (down) to
highlight
Channel Memory.
C. Press MOVE • to underline the
channel number.
D. Select the channel number
you
want to add or delete with the
number
buttons.
E. Press MOVE • to add or delete
a channel
(you will see Stored
on the screen when added
and
Erased when deleted).
F. Repeat D and E for more
channels.
2O
Advertisement
