Table of Contents
Advertisement
C@nnect @ns
Setup
Why You Should Connect This G-LINK Cable
The G-LINK cable
enables
the GtlDE
Plus+
system
(the on-screen
interactive
program
guide)
to
work
with your VCR and/or
cable
box.
Cable
Box-
If your TV/DVI)
is connected
to a cable box you must
connect
tile G-LINK cable
to
receive
TV program
listings
for your area, and
to tune directly
to a channel
when
the program
guide
is on your TV screen.
VCR--
If your TV/I)VI)
is connected
to a VCR and you don't
connect
tile G-LINK cable,
one-touch
VCR recording
won't
work.
The other
ll.atures
of the guide
will work
properly.
G-LINK cable
/
G-LINK wands
How to Find the Remote
Sensor
You have
to place
tile G-LINK
wands
in l)ront of the remolu
sensor
on tile VCR and/or
cable
box.
Some cable
boxes
and VCRs have
tile remote
sensor
lal)eled
on tile unit. If tile remote
sensor
isn't
labeled
on your VCR and/or
cal)le box, you need
to use tile remote
conm}l
that came
with the VCR
and/or
cable
box to locale
the sensor.
1.
Turn
off tile VCR and/or
cable
box.
2.
Hold the remote control (not tile one that came with your TV/DVD, but the one that came
with the cable box and/or VCt{ to which you're attaching the G-LINK cable) so that it is
touching
the tront ot' the component.
3.
Slowly move the remote control across tile front of tile component
(VCR or cable box) while
you press the power butt(m on and off. You must press and release the power butt(m each
time you move the remote (holding
down the button won't work).
II
II
g -g-
4.
When
the c(}mponent
turns
on, you've
located
the remote
sensor.
Placing the G-LINK Wands
I lace tile G-LINK wands
in t_cont of the remote
sensor
on your VCR and/or
cable box
approximately
one
inch away
l_com the remote
sensor
(see instructions
below).
rvsDvo
rip
If you don't have both a
cable box and a VCR
connected to your
TVIDVD,just coil the cable
of the extra G-LINK wand
with a twist tie and leave it
behind the unit.
,,,U
II
.........
14
Chapter
I
Advertisement
Table of Contents
