Table of Contents
Advertisement
16061510-CHAPTER 1
12/13/02 11:43 AM
C h a p t e r O n e
Y
N
3 W
O U R
E W
Things to Consider Before You Connect
Protect Against Power Surges
• Connect all components before you plug any of their power cords into the wall outlet.
• Turn off the TV/VCR/DVD and/or component before you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet
packed with your TV/VCR/DVD.
Protect Components from Overheating
• Don't block ventilation holes on any of the components. Arrange the components so that air can
circulate freely.
• Don't stack components.
• When you place components in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won't
flow around other components.
Position Cables Properly to Avoid Audio Interference
• Insert each cable firmly into the designated jack.
• If you place components above the TV/VCR/DVD, route all cables down the side of the back of the
TV/VCR/DVD instead of straight down the middle.
• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead
cables away from audio/video cables.
Important Stand and Base Safety Information
Choose the location for your TV/VCR/DVD carefully. Place the TV/VCR/DVD on a stand or base that is of
adequate size and strength to prevent the TV/VCR/DVD from being accidentally tipped over, pushed
off, or pulled off. This could cause personal injury and/or damage to the TV/VCR/DVD. Refer to the
Important Safeguards sheet packed with your TV/VCR/DVD.
Use Indirect Light
Don't place the TV/VCR/DVD where sunlight or room lighting will be directed toward the screen. Use
soft or indirect lighting.
Cables Needed to Connect Components to Your TV/VCR/DVD
The pictures below show the cables needed for the connections represented in this book.
Notes: Audio/Video cables (A/V cables for short) are usually sold as a bundled set, but the connection picture in this
book shows each cable separately for better visibility.
This TV/VCR/DVD's OPTICAL DIGITAL OUT jack fully complies with the international standard governing this type of
jack (IEC958), and is designed for connection to a Dolby Digital (AC-3® or PCM) receiver or Dolby Digital (AC-3 or
PCM) decoder. Older equipment, some of which is not fully compliant with IEC958, may not be compatible with the
Dolby Digital bitstream. Such a connection using anything other than Dolby Digital AC-3 or PCM receiver or decoder
could create a high noise level, causing damage to headphones or speakers.
Coaxial cable
Page 3
C
U
AY
O M B I N AT I O N
Audio/Video cable
N I T
Optical Digital cable
C
O
HAPTER
NE
: Y
N
3
C
U
OUR
EW
WAY
OMBINATION
3
NIT
Advertisement
Table of Contents
