ProForm XP 690t User Manual page 11

9. 9
With the help of a second person, hold the
handrail assembly (B) upside down near the
console assembly (A), Connect the ground
wires from the console assembly to the Console
Ground Wires (6) from the handrail assembly.
Insert the console wire (C) into the track in the
console assembly (A).
Insert the Ground Wires into the hole in the con-
sole assembly (A) as you set the handrail as-
sembly (B) into the console assembly, Make
sure the console wire (C) stays in the track.
Be careful not to pinch any wires.
A
Ground
Wires
B
02
10. Attach the handrail assembly (B) to the console
assembly (A) with two #8 x 3/4" Washer Head
Screws (2). Start both Screws before tighten=
ing them. Be careful not to overtighten the
Screws.
Attach a Console Clamp (105) to the console
assembly (A) with two #8 x 1" Screws (107),
Start both Screws before tightening either of
them. Be careful not to overtighten the
Screws. Attach the other Console Clamp the
same way.
Remove the wire ties from the Handrails (82,
83), Press the 5/16" Cage Nuts (38) back into
place, if necessary.
10
82
83
A
2--?,
11