Components - Pioneer LaserDisc CLD-D704 Operating Instructions Manual

NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
COMPONENTS
A detailed description is provided on the indicated page (s).
Remote control buttons with the same names or marks as buttons on the front panel of the player control the same operations
as the corresponding front panel buttons.
AUDIO button ... p. 21
POWER button
Pressto turn the power on and off.
DISPLAY button ... p. 38
PGM button ... p. 34
EDIT button ... p. 36
LIGHTING button ... p. 17
CHP/TM button ... p. 27, 28
RANDOM button ... p. 29
Digital level control button
(D-LEVEL CTRL) ... p. 23 [
.__J
HILITE/INTRO button ... p. 26
These buttons light up.
JOG MODE button/
JOG indicator.., p. 25
DISC SIDE A/B buttons ... p. 18
D/A/CX button ... p. 20, 21
V-DNR button ... p. 24
-- EJECT button (m/A) ... p. 18, 20
-- REPEAT A/B buttons ... p. 32
CLEAR button
Used to clear the repeat mode, program
mode, random play mode or intro scan
mode. This button is also for use in
correcting input digits.
Direct search/Digit buttons
... p. 27, 28
MULTI-SPEED buttons (--, +/<, I_)
.. p. 30
STEP buttons (<11, I1_) ... p. 30
PAUSE button (11)... p. 20
__ PLAY button (I,-) ... p. 19
-- SCAN buttons (<1<, IH_) ... p. 25
-- SKIP buttons (1_<, 1_1) ... p. 27, 35
--
SHU3-rLE ring ... p. 23, 24, 25
JOG dial ... p. 24, 25
When operating the remote control unit, point the unit's
infrared signal transmitter at the remote control receiver
on the front panel of the player. The remote control unit
can be used within a range of about 7 meters (23 feet)
from the remote sensor, and within angles of up to about
30 degrees.
NOTES FOR USING THE REMOTE CONTROL UNIT
• If a plug is connected to the CONTROL IN terminal at the rear
of the player, remote control operations cannot be done with
the remote control unit aimed at the player's remote control
sensor, Aim the remote control unit at the AV ampfifier or the
component display's sensor instead,
• If there Is any obstacle between the remote control unit and
the player, or if the unit is held at too large an angle relative to
the front panel of the player, the signal from the remote control
unit will fail to reach the remote sensor.
• If the player is operating in the vicinity of other appliances
generating infrared rays, or if other remote control devices using
infrared rays are used near the player, the player may operate
improperly. Conversely, if the player's remote control unit is
operated in the vicinity of other applianceswhich use an infrared
remote control device, the other appliance may operate
improperly. If this should happen, change the place of installation
so that improper operation does not occur.
• If the range of
operation of
the remote control unit becomes
too short, replace the batteries.
• When the unit is not to be used for a long period of time (more
than one month), remove the batteries to prevent them from
leaking inside the compartment. If leakage occurs, wipe up the
liquid inside the compartment and replace the batteries with
new ones.
• Do not place books or other objects on the remote control unit,
since they might depress the buttons and run down the batteries.
• If the remote control sensor window is in a position where it
receives strong light such as sunlight or fluorescent light, control
may not be possible.
15
<VRB 7742>