RCA M29400 User Manual page 33

References
Trouble Checks
Trouble Checks and Adjustments
Remote
Buttons don't work when
you press them
Press "IVto set the remote to control the TV. See buttons on page 6-7.
Remove batteries and hold number I for at least 60 Seconds to drain the
microprocessor inside the remote. Release number 1, replace the
batteries, and (if necessary) reprogram the remote.
Remove all batteries for approximately 12 hours. Then replace batteries
and (if necessary) reprogram the remote.
Works part or none of
the time
Clear the path between the remote and TV of any objects.
Aim the remote at the component you are trying to control.
Press TV so remote will control TV.
Make sure batteries in the remote are not dead.
See if batteries are placed in remote correctly. See batteries; page 2.
Can't select certain channel
Press number buttons. Channel may not be in memory. See autoprogram
on page 20.
Make sure TV/VCR switch on VCR is in the TV position.
For numbers over 100, press and hold I until 1-- appears, then press the
other two numbers.
Set Cable/Air feature to Cable for channels higher than 69. See page 27.
TV Turns on or off
Turns off by itself
Turns on by itself
Does not turn off at
Alarm Time
Check Sleep Timer. See sleep timer on page 23.
Wait 30 seconds and turn on again, a power surge may have occured.
Check Alarm Off time. See alarm clock on page 24.
Check Alarm On Time. See alarm clock on page 24.
Check clock time. See clock on page 3.
Make sure alarm is turned on or off. See alarm clock on page 24.
check clock time. See clock on page 3.
, 31