Poulan Pro BH 2660 Instruction Manual page 13

,_ 1st Cut
Using a support stand
2 nd Cut ",
ut
/ I st Cut
LIMBING AND PRUNING
WARNING:
Be alert for and guard
against kickback. Do not allow the moving
chain to contact any other branches or ob-
jects at the nose of the guide bar when limb-
ing or pruning, Allowing such contact can re-
sult in serious injury,
WARNING:
Never climb into atree
to limb or prune. Do not stand on ladders,
platforms, a log, or in any position which can
cause you to lose your balance or control of
the saw.
IMPORTANT POINTS
• Work slowly, keeping both hands firmly
gripped on the saw. Maintain secure foot-
ing and balance,
• Watch out for springpoies, Springpoles
are smatl size limbs which can catch the
saw chain and whip toward you or pull you
off balance, Use extreme caution when
cutting small size limbs.
• Be alert for springback, Watch out for
branches that are bent or under pressure.
Avoid being struck by the branch or the
saw when the tension in the wood fibers is
released.
• Keep a clear work area, Frequently clear
branches out of the way to avoid tripping
over them,
LIMBING
• Always limb a tree after it is cut down. Only
then can limbing be done safely and prop-
erly,
• Leave the larger limbs underneath the
felled tree to support the tree as you work.
• Start at the base of the felled tree and work
toward the top, cutting branches and
limbs. Remove small limbs with one cut.
• Keep the tree between you and the chain.
Out from the side of the tree opposite the
branch you are cutting.
• Remove larger, supporting branches with
the cutting techniques described in BUCK-
ING WITHOUT A SUPPORT.
• Always use an overcut to cut small and
freely hanging limbs. Undercutting could
cause limbs to fall and pinch the saw.
PRUNING
_bWARNING:
Limit pruning to limbs
shoulder height or below. Do not cut if
branches are higher than your shoulder. Get
a professional to do the job.
• Make your fist cut 1/3 of the way
through the bottom of the limb.
• Next make a 2nd cut all the way
through the limb. Then cut a third
overcut leaving a 1 to 2 inch (2.5 - 5 cm)
collar from the truck of the tree.
_ThiPrl ! Sec°nd cut_'_
Collar tit.__
"X,_!V _ First cut
(/ Pruning technique
_lk WARNING:
Disconnect the
spark
plug before performing maintenance except
for carburetor adjustments.
We recommend all service and adjustments
not listed in this manual be performed by an
authorized service dealer.
HELPFUL TIP
IMPORTANT: Have all
fj_lmll_ , repairs other than the ree-
If _,_ _ ommended maintenance
_1_ .,_J described in the instruction
\_41F'/" manual performed by an
authorized service dealer.
!f any dealer other than an authorized
service dealer performs work On the
product, Poulan may not pay for repairs
under warranty. It is your responsibility
to maintain and perform general mainte-
nanoe.
13