Outdoor Unit; Screen Configuration; Setting The Day Of The Week And Time; How To Change The Screen - Mitsubishi Mr.Slim SEZ-KD09 Operation Manual

2. Parts Names
• Outdoor unit
Power
Refrigerant
Pipes
Ground
Q
3. Screen Configuration
Function Selection ofremote controller
Set Day/Time
<Screen Types>
For details on setting the language for the remote controller display, refer
to Section 8: Function Selection.
The initial language setting is English.
• Function Selection of remote controller:
Set the functions and ranges available to the re-
mote controller (timer functions, operating restric-
tions, etc.)
• Set Day/Time: Set the current day of the week or time.
• Standard Control Screens:
View and set the air conditioning system's oper-
ating status
• Timer Monitor: View the currently set timer (weekly timer, sim-
ple timer, or Auto Off timer)
• Timer Setup: Set the operation of any of the timers (weekly
timer, simple timer, or Auto Off timer).
<How to change the screen>
@ Hold down both the Mode button and the Timer On/Off button for 2
seconds.
(_) Press the Timer Menu button.
© Press the Mode (Return) button.
(_) Press either of the Set Time buttons (V or /X).
4. Setting the Day of the Week and Time
[]
Day of the Week &
Time display
®
Note:
• The day and time will not appear if clock use has been disabled at the Func-
tion Selection of remote controller.
• After the power supply returns, the indoor unit does not operate for three
minutes. Above operation is normal.
• If the setting 0 or (_) is set, the 12 hour clock (AM/PM) will be displayed.
C)CHANGE LANGUAGE setting = English [Refer to page 12]
(_)Temperature display setting = °F [Refer to page 12]
If the settings above are not set, the 24 hour clock (rail road time/military
time) will be displayed.
Only "Set Day/Time", "Standard Control Screens", "Timer Monitor" and
"Timer Set UP" screens are applicable to the settings,
4
,_ Day of the Week Setting
[] Time Setting
1. Press the V or /X Set Time button @ to show display D.
2. Press the Timer On/Off (Set Day) button @ to set the day.
* Each press advances the day shown at [] : Sun -_ Mon -_ ... -_ Fri -_
Sat.
3. Press the appropriate Set Time button @ as necessary to set the time.
*As you hold the button down, the time (at [_) will increment first in
minute intervals, then in ten-minute intervals, and then in one-hour in-
tervals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
,a button @ to lock in the values.
Note:
• Your new entries at Steps 2 and 3 will be cancelled if you press the Mode
(Return) button (_) before pressing the Filter .u button O.
5. Press the Mode (Return) button (_ to complete the setting procedure.
This will return the display to the standard control screen, where [] will
now show the newly set day and time.