Table of Contents
Advertisement
3.
To select both video and audio for viewing and muting, if necessary, press and
release the RGBHV button and the Audio button (figure 3-28).
N This example shows the indications that the front panel displays if example 1,
example 2, and example 3 have been completed.
I/O
RGBHV AUDIO
Press the RGBHV button
Press the Audio button
to toggle on and off.
to toggle on and off.
The LED lights when
The LED lights or
selected.
blinks when selected.
Until you select an input or output, the buttons light for all untied outputs or
outputs with audio broken away.
Figure 3-28 — Select RGBHV and audio
N Output mutes are protected when front panel Lock mode 2 is selected. You
can view the mutes in Lock mode 2 but you cannot change them from the front
panel.
If you try to perform steps 4 and 5 while front panel Lock mode 2 is selected, the
actions are ignored.
4.
Press and hold the Output 3 button and the Output 4 button (figure 3-29) for
approximately 2 seconds until the LEDs begin to blink. The output 3 and
output 4 video and audio signals are muted.
Press and hold the Output 3
and Output 4 buttons.
The LEDs blink to indicate that the
RGBHV and audio outputs are muted.
= Blinking LED
Figure 3-29 — Mute the outputs
In this example, the Audio LED blinks to indicate audio breakaway
(assuming you have performed examples 1, 2, and 3).
1
2
3
4
OUTPUTS
3
4
5
OUTPUTS
2 seconds
3
4
5
OUTPUTS
Release the buttons.
MVX VGA A Matrix Switchers • Operation
5
6
7
8
3-19
Advertisement
Table of Contents
