Mitsubishi Electric DLP C9 Series Owner's Manual page 9

1. Basic Setup and Operation 9
TV Control Panel
Buttons on the control panel duplicate some keys on
the remote control.
• Refer to upper labels when no TV menus are dis-
played.
Refer to lower labels when using TV menus or after
activating a special function.
-VOL + - OH + ACTIVITY
_ ENTER
Controls on 737 and C9 series TVs. 837 series controls
are similar and are located next to the STATUS indicator.
STATUS Light
Key
O off
O Steady On
O Slow Blinking
_) Fast Blinking
System Reset
if the TV fails to respond to the remote control, the
control-panel buttons, or will not power on/off, perform
System Reset. Recent setting changes made before
using System Reset may be lost.
To perform System Reset, press and hold the POWER
button on the control panel for ten seconds.
Panel-Lock Release
To release the Panel Lock from the TV control
panel, press and hold the ACTWITY button on the
control panel for ten seconds. You can release the
Panel Lock with the TV powered either on or off.
To activate the Panel Lock, use the Lock menu,
page 44.
I If You Power Off the TV by Mistake
,,,_
1. Press POWER again, within about 60 seconds,
to have the TV come back on immediately.
2. if the status indicator starts rapidly blinking
green (about 60 seconds after you shut off
power), wait a few moments for the status indi-
cator to stop blinking and press POWER to turn
the TV on again.
None O TV is powered off. Normal operation.
Green 0 TV is powered on. Normal operation.
Green O TV powered off, auto-on TV Timer Normal operation. TV can be turned on at any time.
is set.
Green _ TV just powered off and lamp is
cooling.
Yellow
Red
Red
1. Lamp failure
2. No lamp installed.
Lamp access door is open or not
sec u re.
TV may require service.
LED starts to blink 60 seconds after turning off TV. TV can be
turned back on before blinking starts or after blinking stops, but
not while the indicator is blinking. Normal operation.
Replace the lamp. See "Lamp-Cartridge Replacement and
Cleaning" on page 69.
TV will not operate until lamp access door is secured. See
"Lamp-Cartridge Replacement and Cleaning" on page 69.
Turn off the TV and unplug the set from the AC power source.
Wait one minute and then plug the set back in. See Appendix E.
If the red LED is still on, contact your dealer or a Mitsubishi
Authorized Service Center. Go to www.mitsubishi-tv.com or call
1-800-332-2119 to receive Authorized Service Center information.