Fedders MEP09D2BC0M Installation & Operation Manual page 6

Control Panel ooooooooooooooooooooooooooooooooooooooooooooooooooo
Warning
Light
qlP
COOL HEAT HiGH
9D
rAN lOW
@©®
Power JMII"_ re°DE FaN S ,EED
Control Control Fan Speed
Control
_ MAYFP
Display
Mode
Indicators
O
TIMER
SET
Q
TIMER
Timer Timer/Tern p Set
Control Controls
Power Control
The power control turns the unit on and off.
Warning Light
Condensed water may accumulate in the unit. If
the internal tank becomes full, the Warning Light
will shine and the unit will not operate until the
unit has been drained. See Draining Excess Water
section for instructions on how to drain the water.
Mode Control
The Mode Control has 4 settings:
Cool, Heat, Dehumidify and Fan.
The settings are adjusted with the Mode Control
button. A light will indicate which setting is
currently being used.
Cool Mode
When Cool mode is selected, the indicator
light will shine green. During the cooling
mode the air is cooled and hot air is
exhausted to the outside air through the
exhaust tube. Adjust fan speed and
temperature to suit your desired comfort
level. Note: The air exchange hoses must
vent outside the room when using Cool
Mode.
Heat Mode
When the Heat mode is selected the
indicator light will shine red. Heated air is
circulated throughout the room. Adjust fan
speed and temperature to suit your desired
comfort level.
Note: The air exchange hoses must vent
inside the room when using Heat Mode.
Caution: Heat/Cool models or units with
electric heat are designed to be used only as
a supplemental heat source. They should be
used in addition to regular heating systems
and never as the primary source of heat.
Dehumidify Mode
When Dehumidify mode is selected, the indicator
light will shine orange. Air is dehumidified as it
passes through the unit, without being in full
cooling mode. The fan will operate in Med speed.
Fan speed is not adjustable in Dehumidify mode.
Note: The air exchange hoses must vent inside the
room when using Dehumidify Mode.
Fan Mode
When Fan mode is selected the LED light will shine
yellow. Air is circulated throughout the room with
no cooling. (Note: unit does not need to be vented
in Fan mode.)
Fan Speed Control
The Fan Speed Control has 3 settings:
High, Medium, and Low.
Timer Control
Auto turn off:
With machine in fan mode, press timer button to
select number of hours you would like the unit to
run in air conditioning mode until it automatically
shuts off.
Auto turn on:
With machine powered off, press timer button to
select number of hours until you would like the
unit to automatically start running in air
conditioning mode.
Temp/Timer Set Controls
Used for adjusting the timer and thermostat.
The default display is room temperature.
In cooling mode, when "+" or "-" button is pressed
the set temperature is displayed and may be adjusted.
After 15 seconds the display will revert back to room
temperature. Temperature is only adjustable in Cool
and Heat mode.
Note: By pressing both Temp/Timer Set buttons
at the same time, the display will toggle
between Celsius and Fahrenheit.
6