Rear View - Maytag MIM1555YRS0 User Instructions

Read alldirections before y oubegin.
IMPORTANT:
Plumbing shall b einstalled inaccordance withthe
International Plumbing Code andanylocal c odes a nd
ordinances.
• Use copper tubing orWhirlpool supply line, P art N umber
8212547RP, and check f orleaks.
• Install tubing only inareas w here t emperatures willremain
above f reezing.
Tools needed
Gather therequired tools andparts before s tarting i nstallation:
• Flat-blade screwdriver
• 7/le" and1/2" open-end wrenches ortwoadjustable wrenches
• 1/4" nutdriver
NOTE: Donotuse a piercing-type or3/le" (4.76 mm) s addle valve
which reduces water f lowand clogs more easily.
Connecting t heWater L ine
1.
2.
Turn off main water supply. Turn on nearest faucet long
enough to clear line of water.
Using a 1/2"copper supply line with a quarter-turn shutoff
valve or the equivalent, connect the ice maker as shown.
NOTE: To allow sufficient water flow to the ice maker a
minimum 1/2"size copper supply line is recommended.
A
I/ m
B
3.
A. Bulb
B. Nut
Now you are ready to connect the copper tubing. Use 1/4"
(6.35 mm) OD soft copper tubing for the cold water supply.
• Ensure that you have the proper length needed for the
job. Be sure both ends of the copper tubing are cut
square.
Slip compression sleeve and compression nut on copper
tubing as shown. Insert end of tubing into outlet end
squarely as far as it will go. Screw compression nut onto
outlet end with adjustable wrench. Do not overtighten.
4.
Place the free end of the tubing into a container or sink, and
turn on main water supply and flush out tubing until water is
clear. Turn off shutoff valve on the water pipe.
NOTE: Always drain the water line before making the final
connection to the inlet of the water valve to avoid possible
water valve malfunction.
5. Bend the copper tubing to meet the water line inlet which is
located on the back of the ice maker cabinet as shown.
Leave a coil of copper tubing to allow the ice maker to be
pulled out of the cabinet or away from the wall for service.
REAR VIEW
A. Water supply tube clamp
B. Vent hose (drain pump models only)
C. Inlet water tube clamp and supply
fine connector
D. Drain hose (drain pump models only)
6.
7.
Remove and discard the short, black plastic tube from the
end of the water line inlet.
Thread the nut onto the end of the tubing. Tighten the nut by
hand. Then tighten it with a wrench two more turns. Do not
overtighten.
NOTE: To avoid rattling, be sure the copper tubing does not
touch the cabinet's side wall or other parts inside the cabinet.
A B C D
A. Line to ice maker
B. Nut (purchased)
C. Ferrule (purchased)
D. Suppfied fine from ice maker
8. Install the water supply tube clamp around the water supply
line to reduce strain on the coupling.
9. Turn shutoff valve ON.
10. Check for leaks. Tighten any connections (including
connections at the valve) or nuts that leak.
A. Compression sleeve
B. Compression nut
C. Copper tubing