Maytag PY-1 User Manual page 5

Cycles and options may vary by model.
minutes to reduce wrinkling. If the load is not removed
from the dryer, the cycle will advance to WRINKLE
OUT which provides additional unheated tumbling
time. WRINKLE OUT is optional on select models.
(See Step 2).
Time Dry/Air Fluff
This cycle can be used to regulate the drying time. Use
with Air Fluff, Low, Medium (select models) or Regular
temperature settings. For timed drying, turn the control
dial clockwise until the pointer points to the proper
time setting in the Time Dry/Air Fluff cycle.
Wrinkle Release will release wrinkles from items that
are clean and dry but only slightly wrinkled, such as
from a crowded closet or suitcase, or from sitting in the
dryer too long after the cycle has ended. Wrinkle
Release provides 10 minutes of tumbling followed by
five minutes of cool-down tumbling and can be used
with any temperature selection.
Push the Control
Notei Using the Air Fluff temperature Setting will
l)ia| in to Start
require a longer drying time, Push the control dial in to start the dryer. The dryer
door must be closed for the dryer to start.
Special Options
Damp Dry is located on the Time Dry/Air Fluff section
of the dial. It is designed to partially dry items and can
be used with any temperature selection. Damp Dry
will provide 20 minutes of tumbling time, followed by
5 minutes of cool-down tumbling.
Note: The dial can be tm_ed in either direction to
select a cycle. Once started, the dial will not advance
at a specific rate during the Auto Dry cycles. At first
the dial may not advance at all. Toward the end of the
cycle (when the load begins to dnd) , the dial will
advance at a more regular rate and much more quick-
ly. This is normal operation.
4