Using The Dryer - Maytag D-8 User Manual

USING THE DRYER
Che :k she int FiJte
Clean the lint filter after each load. It's best to
check this when the dryer is empty to prevent lint
from falling onto items inside the dryer.
To clean, pull the filter out and remove any lint.
(See illustration below.) Failure to clean the filter
will cause loads to take longer to dry and make
the dryer operate less efficiently.
Replace the filter by pressing it firmly into position.
NOTE: Do not operate the dryer without the lint
filter in place.
Load the Dryer
A proper washer load is a proper dryer load. Do
not combine loads. Avoid drying very small loads
and mixed loads of heavy, hard-to-dry items and
lightweight ones. Normal sized loads dry most
efficiently. (A full load is shown below.)
NOTE: If you are using a dryer-added fabric
softener, it should be added now. Adding
one after the load is warm can cause
greasy-looking softener stains. Refer to
the Maytag Laundering Guide for
removing dryer-added fabric softener
stains.
Wha ¢ nnot Be Dryer Dried
The following items should not be dried in a dryer
unless specifically recommended by the
manufacturer on the care label.
1. Fiber glass items (curtains, draperies,
bedspreads, etc.)
2. Woolens
3. Rubber-coated items, plastics and items with
plastic trim (on a heat setting)
For specific drying instructions, please refer to the
Operating Instructions section on pages 4 and 5
or the MAYTAG LAUNDERING GUIDE.
PAGE 6