Tape Operation - Panasonic Omnivision PV-C1331W Manual

Search System is ...
Each time a recording is made, an invisible index mark is placed on the tape.
When timer recordings are made, program index and information are also included.
These index marks can be used to access or scan recordings.
Go directlyto the desired recording.
Press SEARCH
in Playback or
Stop mode to
display INDEX
SEARCH screen.
Press number
keys
to select the
recording number.
• To calculate
number, see below.
Press FF or REW
to start search.
• Playbegins at search
end,To search
forwardor back1
index, p ressFF or
REW whilescreen
left in displayed(10
seconds).
• To calculate the Index Number
Example 1:
To go to rec,2 from rec,4, enter3 and pressREW,
Example 2:
To goto rec,6 from rec,2, enter4 andpress FF,
i, I s t, I
NOTE: _,indicates start points of each recording.
• Make each entry within 10 seconds, or the
Index Search mode will be canceled.
• If Index Search is started very close to an
index mark, that index mark may not be
counted in the search.
24
Locates end point of recording for continuity.
Press SEARCH twice in Playback or
Stop mode to display PROGRAM END
SEARCH screen.
, Press FF
to start search.
Example of Program End Search operation,
PLAYBACK DIRECTION
II T _'_' IIIDII
Pr°gF°r_<_rBLANK R
PressSEARCHbutton f_
FF
Fio.2
I_l[
I cLANK I_l|PrOgta_2 _ eLANK II
I
P_ess SEARCH button f_!_
FF
If searchexceedsa few secondsin BLANKarea.
PressSEARCHbutton
1
1 B_NK IIII PrCgram;I I
Upon locating end point...
The unit searches slightly past end point,
reverse searches, and plays the last few
seconds of the program, then stops.
IIT
Pr°_lml 1 (BLANK) J_ll _2('BLANK)
I
PressSEARCHbutton is_c_
FF _ ! REVERSE
• PI_Y _., ,.,..*_ ......... _ SEARCH
s_'oP
0
• if Program End Search is started very close
to an index mark, that mark may be
skipped over.
• To cancel, press PLAY or STOP.