Table of Contents
Advertisement
l
KX-F1200
SAFETY PRECAUTIONS
i.
bJelu_ _urvJcJt]g, u, Jp_uguJu F, u wer cord to prevent an electric shock.
2. When replacing parts, use only the manufacturer's recommended
components.
3. Check the condition of the power cord. Replace if wear or damage is evident.
4. After servicing, be sure to restore the lead dress, insulation barriers, insulation papers, shields, etc.
5. Before returning the serviced equipment to the customer, be sure to perform the following insulation resistance test to
prevent the customer from being exposed to shock hazards.
INSULATION
RESISTANCE
TEST
1. Unplug the power cord and short the two prongs of the plug with a jumper wire.
2. Turn on the power switch.
3. Measure the resistance value with an ohmmeter between the jumpered AC plug and each exposed metal cabinet part
(screwheads, control shafts, handle brackets, etc.).
"Note: Some exposed parts may be isolated from the chassis by design. These will read infinity.
4. If the measurement
is outside the specified limits, there is a possibility of a shock hazard.
The equipment should be repaired and rechecked before it is returned to the customer.
Exposed --
metal
part
r
Resistance = more than 1M
(at DC 500 V)
FOR SERVICE TECHNICIANS
los and LSIs are vulnerable to static electricity.
When repairing, the following precautions will help prevent recurring malfunctions.
1) Cover the plastic parts boxes with aluminum foil.
2) Ground the soldering irons.
3) Use a conductive mat on the worktable.
4) Do not touch IC or LSI pins with bare fingers.
Advertisement
Chapters
Table of Contents
