Specifications - LG DLE1101W Owner's Manual

SPECIFICZ_iTION S 35
Before calling for service (cont.)
Problem POssible Causes SOlutions
Clothes take too
long to dry
Clothes are shrinking
CHECK FILTER light
is on during the
drying cycle
FLOW SENSE
TM
indicator shows four
bars during the drying
cycle
The display shows
"d 90", "d95"
. Load is not properly sorted.
. Large load of heavy fabrics.
. Dryer controls are not set properly.
. Lint filter needs to be cleaned.
. Exhaust ducts blocked, dirty, or duct run is
too Iong.v
. House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
. Dryer is overloaded.
. Dryer is underloaded.
. Garment care instructions are not being
followed.
. Separate heavy items from lightweight items. Larger and heavier items take
longer to dry.
. Heavy fabrics take longer to dry because they tend to retain more moisture.
To help reduce and maintain more consistent drying times for large and heavy
fabrics, separate these items into smaller loads of a consistent size.
. Use the appropriate control settings for the type of load you are drying.
. Make sure the lint filter is cleaned before every load. With some loads that
produce high amounts of lint, it may be necessary to clean the filter during the
cycle.
. Confirm that the exhaust ductwork is properly configured and free of debris,
lint, and obstructions. Make sure that outside wall dampers can open properly
and are not blocked, jammed, or damaged.
. Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the
problem is a circuit overload, have it corrected by a qualified electrician.
. Divide larger loads into smaller loads for drying.
. If you are drying a very small load, add a few extra items to ensure proper
tumbling action.
.To avoid shrinkage, please carefully follow the fabric care instructions for
your garment, because some fabrics will naturally shrink when washed. Other
fabrics can be washed but will shrink when dried in a dryer. Use a low or no
heat setting.
. Lint filter is almost clogged or full. . Pause the drying cycle and clean the lint filter.
. Ductwork is too long or has too many turns/ . Install a shorter or straighter duct run. See the Installation Instructions.
restrictions.
. Significant blockage of the ductwork due to
lint buildup or debris.
• The appliance has detected a restriction in
the external dryer venting.
.The duct work is about 90%-95% blocked.
("dg0"or"d95"error code displayed 2 hours
only)
. House exhaust system blocked.
. Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may be longer.
• If exhaust restrictions are sensed by the FLOW SENSE
TM
system, the indicator
will remain on for two hours after the end of the cycle. Opening the door or
pressing the POWER button will turn offthe display.
. Do not use the dryer until the exhaust system has been cleaned and/or
repaired. Using the dryer with a severely restricted exhaust is dangerous and
could result in a fire or other property damage.
. Check the outside dryer vent while the dryer is operating to make sure there is
strong airflow.
. If the exhaust system is extremely long, have it repaired or rerouted.
. Keep the area around the dryer clean and free of clutter.
. Check vent hood for damage or lint clogging.
. Make sure the area around the vent hood is clear.
SPECIFICATIONS
Dryer" Models DLEIIO1W DLG1102W
Description Dryer
Electrical requirements* Gas dryer : 120 V- 60 Hz 400 W
Electric dryer : 120/240 V- 60 Hz 26 A
Gas requirements* NG 4-10.S inches WC
LP: 8-13 inches WC (Gas Models only)
Dimensions 27" (W) X 28 IVI6" (D) X 40 V16" (H), S01/4" (D with door open)
68.6 cm (W) X 73.4 cm (D) X 102 cm (H), 127.5 cm (D with door open)
Net weight 125.5 Ibs (56.9 kg)
Drying capacity
- Normal cycle IEC 7.3 cu.ft. (22.5 Ib/10.2 kg)