Panasonic SC-HT733 Operating Instructions Manual page 5

I HT930 I
!i!i!i!i!i/iiiiill IIIIIIII iiii!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i
To prevent the speaker cables from being pulled out of the pipes, leave the plastic wrap on the pipes while
assembling the speaker stands.
t
! Assemble the speaker stands.
O Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the hole, and then pull
the rest of the cable through the base.
2
Attach the stands to the speakers.
Ensure the stand is fastened on straight by gradually tightening the
top and bottom screws alternately until fully tightened.
_ Long screws
Olnsert the pipe.
Base
You can also attach to the lower rear of the speaker.
The height of the speaker can be changed 'when attaching the
stand to the upper rear or lower rear of the speaker.
3
Pipe Match the groove and these
_'_ _ holes with the base when you
Groove [/_/_/_// insertthe pipe.
Pipe support
Base
Insert the pipe while gently
pulling on the speaker cable.
O Secure the pipe to the base.
Ensure the screws ere securely fastened.
Connect the speaker cables.
Rear of the speaker
Press the speaker cable into the
groove.
If there is any excess speaker cable, thread the speaker cable
into the opening near the top of the pipe while pulling the speaker
cable from the bottom of the base.
Short screws
Before proceeding to the next step, please remove the plastic
wrap from the pipe.
A
Secure the speaker cables to the bases.
Press the speaker cable into
the base cover groove as far
as possible. Rear side
of base
Cal:
Groove
• Preventing the speakers from falling over
Preparation
Attach screw eyes (not included) to secure the speakers to the
wall (-_ diagram right).
• You will need to obtain the appropriate screw eyes to match
the walls or pillars to which they are going to be fastened.
• Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result in damage to the wall or speakers. HT93O
To prevent the speaker from failing over, thread the string
(not included) from the wall to the speaker as shown and
tie tightly.
Screw eye (not included)
String (not included)
speaker Approx. 150 mm (529/3£ _ )
Screw eye (net included)
String (not included)
;peaker Approx. 150 mm (529/3_ ")