The Water Inlet Filter - LG WM2032HW Owner's Manual

Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock hazards.
When disposing of the appliance, cut off the power cable, destroy the plug, and disable the door lock to prevent
young children from being trapped inside.
; _The water inlet filter
• " /E "error message will blink on the control panel when water does not enter the dispenser.
• If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.
We recommend cleaning it every few months.
1. Turn off the
water tap.
W
' \i
3. Clean the
filter using
a hard
bristle
brush.
©
;_The drain pump filter
• The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
2. Unscrew
the water
inlet hose.
4. Tighten up
the inlet
hose.
First drain using the drain hose and then open the pump filter to remove objects.
Be careful when draining if the water is hot.
• Allow the water to cool down before cleaning the drain pump filter.
1. Open the ower cover cap (_)
Turn the drain plug ((_) to pull
out the hose.
2. Unplug the drain plug (_:_:),
allowing the water to flow out.
At this time use a vessel to
prevent water from flowing
onto the floor. When water does
not flow any more, turn the
pump filter (_3_) open to the left.
3. Remove out any foreign objects
from the pump filter (/97). After
cleaning, turn the pump filter (/_))
clockwise and insert the drain
plug (_._?) to the original place.
Close the lower cover cap(_).
17