Owner's Manual Washing Machine WM2432HW WM2032HS WM2032HW WM1832CW Please read this manual carefully. It provides instructions on safe installation, use, and maintenance. Retain it for future reference. Record the model and serial numbers of your machine and report this information to your dealer if your machine requires service.
Important Safety Information ...3 Specifications...4 Installation Instructions ...5 Preparation Before Washing...10 Using the Dispenser ...11 Cycles ...13 How to Use the Washer...14 Maintenance ...17 Troubleshooting Guide ...20 Warranty ...23 ¡Æ Direct Drive System The advanced Brushless DC motor directly drives the drum without belt and pulley.
I I M M P P O O R R T T A A N N T T S S A A F F E E T T Y Y I I N N S S T T R R U U C C T T I I O O N N S S WARNING To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions, including the following: •...
Specifications subject to change by manufacturer. ƒR Accessories ¡Æ 1) Per IEC 60456, washes the equivalent of a 3.72 cu. ft. agitator washer. : Front-loading Washing Machine : 120V~ 60Hz : 68.6cm(W) X 75.0cm(D) X 108.6cm(H), 126.5cm(D, door open) ”(D) X 42- 27”(W) X 29-...
Install or store unit where it will not be exposed to temperatures below freezing or exposed to outside weather conditions. Properly ground washer to conform with all governing codes and ordinances. The base opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
Page 7
[Closet door with vents] [Front view] ¡ÆLevel floor Allowable slope under entire washer is 1°. ¡ÆPower outlet Must be within 60 in.(1.5m) of either side of the washer. Do not overload the outlet with more than one appliance. [Side view]...
Page 8
• Make sure that there is no bent in the hose and that it is not crushed. • The Inlet hose which has red connector is for the hot water tap. • Hot and cold water faucets MUST be installed properly to your washer’s water inlet.
Page 9
INSTALLATION INSTRUCTIONS ¡ÆInstallation of drain hose • The drain hose should not be placed higher than 96 in. from the bottom of the washer. • Properly securing the drain hose will protect the floor from damage due to water leakage.
Page 10
INSTALLATION INSTRUCTIONS ¡ÆLevel adjustment • Leveling the washing machine properly prevents excessive noise and vibration. Install the appliance on a solid and level floor surface, preferably in a corner of the room. • If the floor is uneven, adjust the adjustable feet as required.
Wash lint producers and lint collectors separately. • Check all the pockets to make sure that they are empty. Things such as clip, matches, pens, coins, and keys can damage both your washer and your clothes. • Close zippers, hooks, and strings to make sure that these items do not snag on other clothes.
Detergent usage may need to be adjusted for water temperature, water hardness, size and soil level of the load. For best results, avoid using too much detergent. NOTE : Liquid detergent will drain into the washer drum as it is added. 1. Prewash Detergent Compartment...
Page 13
NOTE : If you are using the Prewash option with Main wash, powdered detergent must be used in the main wash compartment since liquid detergent will drain into the washer drum as it is added. 3. Liquid Bleach Compartment • Add measured liquid chlorine bleach to this compartment.
HOW TO USE THE WASHER ¡ÆWM2432HW ¡ÆWM2032HS / WM2032HW ¡ÆWM1832CW 1. Cycles • Rotate the Cycle selector knob to select cycle designed for different types of fabric and soil levels. • Each cycle has a preset Water Temperature, Spin Speed, Soil Level, and Option.
Page 16
HOW TO USE THE WASHER 3. Beeper • Choose High / Low / Off. 4. Wash / Rinse Temperature • Select a water temperature based on the type of load you are washing. • Follow the fabric care label and chart below for best results.
Power button. You can thereby lock the washer while it is operating. DOOR LOCKED • Lights whenever the door of the washer is locked. • The door can be unlocked by pressing the Start/Pause button to stop the washer.
MAINTENANCE Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock hazards. When disposing of the appliance, cut off the power cable, destroy the plug, and disable the door lock to prevent young children from being trapped inside.
Page 19
NOTE : Do not use any cleaning substance on the main dispenser but water. It is possible for cleaning substances to drain into the tub. If this should happen, set the washer for a rinse and spin cycle to remove any cleaning substance from the washer before doing a load of laundry.
Page 20
NOTE : Remove hard water deposits using only cleaners labeled as safe for washing machines. ¡ÆWinterizing instructions If the washer is stored in an area where freezing can occur or moved in freezing temperatures, follow these winterizing instructions to prevent damage to the washer: 1.
• Drain hose is bent or clogged. • The drain filter is clogged. Solution Stop washer and check drum and drain filter. If noise continues after washer is restarted, call for service. If sound continues, washer is probably out of balance.
Page 22
Close the door and press the Start/Pause button. After pressing the Start/Pause button, it may take a few moments before the clothes washer begins to spin. The door must lock before spin can be achieved. If the imbalance is detected or if the suds removing program operates, the wash time shall be increased.
Page 23
• The water overfills due to the faulty water valve. • The water level sensor malfunction. • Overload in motor. • Overload in motor. • The washer experienced a power failure. Solution Check another tap in the house. Fully open tap. Straighten hose.