NordicTrack A2350 User Manual page 8

4. 4
Setthe RightUpright S pacer ( 79)ontheBase
(83).Becarefulnotto pinchthe UprightWire
(38).Withthehelpofa second person, h olda
BoltSpacer ( 80)inside the lower endofthe
RightUpright ( 78).Insert a 3/8"x 4" Bolt(6)with
a 3/8"StarWasher ( 9)intothe RightUpright
andtheBoltSpacer. R epeat t his stepwith a
secondBolt
Spacer (80), 3/8" x 4" Bolt (6),
and 3/8" Star Washer (9). Then, set the Right
Upright in the Right Upright Spacer.
Partially tighten the 3/8" x 4" Bolts (6); do not
fully tighten the Bolts yet.
Press a Base Endcap (77) into the Base (83).
78
79
38
83
8O
.
With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (56) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Attach a Base Pad (81) to the Base (83) in the
location shown with a #8 x 1" Tek Screw (2) and
a Base Pad Spacer (13). Then, attach another
Base Pad (81) with only a #8 x 1" Tek Screw (2).
Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),
and the shipping bracket (C) from the Base (83).
Attach a Wheel (84) with the Bolt and the Nut
that you just removed. Do not overtighten the
Nut; the Wheel must turn freely. Discard the
shipping bracket.
2
.
Set the Left Upright Spacer (76) on the Base
(83). With the help of a second person, hold a
Bolt Spacer (80) inside the lower end of the Left
Upright (74). Insert a 3/8" x 4" Bolt (6) with a
3/8" Star Washer (9) into the Left Upright and
the Bolt Spacer. Repeat this step with a sec-
ond Bolt Spacer (80), 3/8" × 4" Bolt (6), and
3/8" Star Washer (9). Then, set the Left
Upright in the Left Upright Spacer.
Partially tighten the 3/8" x 4" Bolts (6); do not
fully tighten the Bolts yet.
Press a Base Endcap (77) into the Base (83).
With the help of a second person, tip the tread-
mill so that the Base (83) is flat on the floor.
6
76
74