Nikon COOLPIX L120 User Manual page 27

_1_ If Turn the camera off, remove the lens cap, and turn the camera on. is displayed
Make sure that the lens cap has been removed, and turn the camera offand then on again.
_1_ Removing the Batteries
Turn the camera off and be sure that the power on lamp and the monitor have turned off be_re
opening the battery chamber/memory card slot cover.
_1_ Additional Precautions Regarding Batteries
• Read and follow the warnings and cautions (_ iii, 126).
• Be sure to read and follow the warnings for the battery on page iii and the section, "The Battery"
(_ 126), before using the battery.
• Do not combine old and new batteries or batteries of different makes or types.
• Batteries with the following defects cannot be used;
Batteries with peeling Batteries with insulation that
does not cover the area
around the negative terminal
Batteries with a flat
negative terminal
_1_ Note on the EN-MH2 rechargeable Ni-MH batteries
When using EN MH2 batteries with the COOLPIX L120, charge the batteries _ur at a time using
Battery Charger MH 73 (_ 123, 12%.
_1_ Battery Type
To improve battery performance, set the Battery type setting (_ 123) in the setup menu (_ 103)
to match the type of batteries inserted into the camera,
The default setting is the type of battery supplied with purchase. When any other type of battery is
used, turn the camera on and change the setting.
[] Alkaline Batteries
Per_rmance of alkaline batteries may vary greatly depending on the manufacturer, Choose a
reliable brand,
[] Alternative Power Sources
To power the camera continuously for extended periods, use an AC Adapter EH 67 (available
separately) (_ 12%. Do not, under any circumstances, use another make or model of AC adapter,
Failure to observe this precaution could result in overheating or in damage to the camera.
[] Power Saving Function (Auto
Off)
If no operations are per_rmed _r a while, the monitor will turn off, the camera will enter standby
mode, and the power on lamp will blink. If no operations are performed for another three minutes,
the camera will turn off automatically.
When the power on lamp is blinking, pressing any of the following buttons will turn the monitor back on.
, Power switch, shutter release button, I_1 button, [] button, or • (_ movie record) button
In shooting or playback mode, the camera will enter standby mode in about 30 seconds (default setting).
• The time allowed to elapse before the camera enters standby mode can be changed from the
Auto off option (_ 116)in the setup menu (_ 103).
m.
15