Locking The Optical Drive; Connecting The Five-Wire Power Connector To - Lenovo 6072CC3 - Thinkcentre M57 2.33G2gb 80Gb Dvdrom Wvb Hardware Installation And Replacement Manual

5. Slide the drive 3 into the bay until it locks in position. See Figure 10.
Figure 10. Locking the optical drive
6. Pivot the drive-bay assembly upward to gain access to the cable connections
7. Reinstall the front bezel.
8. Continue at "Connecting a SATA drive."
Connecting a SATA drive: A serial optical or additional hard disk drive can be
connected to any available SATA connector.
1. Locate the available SATA connector on the system board. See "Identifying
2. Using the signal cable that came with the new drive, connect one end of the
3. Locate one of the extra five-wire power connectors and connect it to the drive.
Figure 11. Connecting the five-wire power connector to the drive
18
ThinkCentre Hardware Installation and Replacement Guide
and connect the drive cables.
parts on the system board" on page 9.
signal cable to the drive and the other to the available SATA connector on the
system board.
See Figure 11.