Replacing The Right-Side Top Panel - Dell Alienware Aurora R3 Service Manual

1 right-side top panel
Replacing the Right-Side Top Panel
1. Follow the instructions in Before You
2. Align the tabs on the right-side top panel with the slots on the chassis and slide the panel into position.
3. Lay the computer on its side.
4. Replace the screw that secures the right side-panel.
5. Replace the drive-bay shroud (see
6. Close the PCI shroud (see Closing the PCI
7. Replace the left side-panel (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
8. Connect your computer and all attached devices to electrical outlets, and turn them on.
Removing the Lighting Board
1. Follow the instructions in Before You
2. Remove the right-side top panel (see
3. Disconnect the lighting-board cable from the connector on the master I/O board.
4. Make a note of the lighting-board cable routing and remove it from the slot on the computer.
5. Remove the three screws that secure the lighting board to the right-side middle panel.
6. Lift the lighting board along with its cable away from the right-side middle panel.
Begin.
Replacing the Drive-Bay Shroud).
Shroud).
Replacing the Left Side-Panel).
Begin.
Removing the Right-Side Top Panel).