3D Video - Mitsubishi WD-82840 Basic Owner's Manual

20 3. TV Features
3D Video
To display 3D content, your Mitsubishi TV requires:
• Active-shutter 3D glasses compatible with any one
of the following:
The TV's internal emitters
A matching external synchronization emitter
connected to the TV's back panel
DLP link
Glasses compatible with the TV's internal emitters
are:
XPAND model 3DG-Xl03 IR glasses made for
Mitsubishi 3D TVs
XPAND model X103 Universal IR glasses
For more information, visit the 3D TV page at
www.mitsubishi-tv.com.
A compatible 3D source device connected to the
TV via HDMI or StreamTV internet and outputting a
3D signal in one of these formats:
Frame Packing 1080p/24-Hz or 720p/60-Hz
Top-Bottom 1080p/24-Hz or 720p/60-Hz
Side-by-Side format, 1080p, 24/30/60-Hz;
720p, 60-Hz
Checkerboard format, 1080p, 60-Hz; (lower resolu-
tions may be supported but will not fill the screen)
Turns off 3D images; displays 3D content
as 2D (you may see two images).
Restores normal TV adjustment options
when viewing an ordinary 2D signal.
Using the TV's Internal Emitters
I<
16ft.
2s . t
Effective range of the
emitters in the vertical
and horizontal planes
16ft.
16ft.
Initial Setup
1, If your 3D glasses came with a synchronization emitter,
connect the unit to the 3D GLASSES EMITTER jack.
Place the emitter at the front of the TV where there is a
clear path to the glasses.
Note: No emitter is required if using the TV's internal
emitters or DLP Link.
Automatic
• Switches the TV to 3D mode and selects the
correct 3D format when the TV detects a 3D
signal from an HDMI 1.4a-compliant device.
• Automatically switches the TV out of 3D
mode when receiving a normal 2D signal.
Usethe Picture >3D Mode
menuto enable3D video.
Choice of Source Formats
If your device is not HDMI 1.4a
compliant, you must choose the
correct setting from this list.
Connecting an external emitter
2, Power on the TV and the source device.
3, Connect the source device to the TV's HDMI input.
4, When the New Device Found screen displays,
name the input.
5, Press EXITto close the New Device Found screen.
Depth
Adjusts the simulated 3D effect
applied to a 2D image. Available
only when Source Format is set
to 2D+ Depth.
For assistance call 1(800) 332-2119