Loading - Maytag MDB8600AWW Use & Care Manual

Loading
Adjustable Racks
(semect modems)
The Adjustabme Upper Rack (semect modems] and
Adjustable Middle Rack can be raised or lowered to
accommodate taller plates, platters, pans, etc. in the
upper, middle or lower racks. Full size dinner plates
can be loaded in the upper rack if it is in the lower
position. Rack is easier to adjust before it is fully
loaded.
To Dower the rack:
1, Pu[[ the rack fully out.
2, Place thumbs on
each lever on
the adjuster
while holding
rack with hands,
Adjusters
3, Press down on
the levers with
thumbs and
push rack down, The rack wi[I come to a stop when
it is in position,
To raise the rack:
1. Pu[[ the rack fully out.
2. Place hands on both sides and lift up until rack
comes to a stop and latches in place.
The dishwasher will not
operate correctmy if the
rack wash arm
connection is aot aligned
with one of the water
inlet boles on back wall
of the dishwasher.
The left and right side adjusters on the racks
must both be fully in the upward or downward
position for proper connection.
Removing the Upper
and Middle Racks
The racks can be removed when tall or oversized items
need to be loaded into the middle or lower rack.
Unload the rack before removing it from the
dishwasher.
To remove rack with push tab rack stops (select
models):
1. Roll the rack '/:_to '/2of the way out.
To remove each plastic push tab rack stop from the
end of each rack, push inward (toward the rack} on
the ridged area of the rack stop. The rack stop will
snap open and can be easily removed by puffing
straight out. Take care
to support the track
while removing rack
stops.
3. Roll the rack all the way
out of the track and
remove from the
dishwasher.
Push Tab
To replace: Rack Stop
Reverse the above procedure to replace the rack into
the dishwasher.
To remove rack with tab-Deck rack stops
(semect models):
1. Roll the rack '/:_to '/2of the way out.
Locate the rack stops at the end of each track.
Squeeze the tab in the middle of the rack stop and
pull the rack stop straight out. Take care to support
the rack while removing the rack stops.
3. Roii the rack aii the
way out of the track
and remove from
the dishwasher.
To replace:
1. Replace the Tab Lock
dishwasher rack by Rack Stop
guiding the wheels into the tracks.
Push each rack stop squarely into the end of the
track until the catch pops into the small hole on the
side of
the track.
5