Basic Playback Video Cassette Playback - Magnavox MRD500VR Owner's Manual

Read
a nd follow the steps below to play a tape.
Turn on theTV. Set it to channel 3 or 4 or its
AUDIO/VIDEO IN channel. This depends on how you
connected the System to aTV. Details are an pages 8-11.
2
With the System's power off, insert a tape in the
cassette compartment. The STANDBY-ON andVCR lights
will appear on the front of the System, If the tape's record tab
has been removed, playback will start automatically.
Or, if the System's power is already on, pressVCR to put the
System in VCR m_de.The red VCR light will appear on the
front of the Sys_tem.
4
5
If play does not start automatically, press VCR, then
press PLAY I_.
Press STOP • to stop playback.
Press REW _ to rewind the tape.
After the tape stops, press STOP/EJECT l___ on the
front of the System to remove the tape.
I Turn on the TV.
Insert a tape in the System.
(D®®
e 6
(D®®O
@®0®
00®®
Press STOP/EJECT HA__on
the System.
Other tape playback features are
on pages 42-46.
If AUTO REPEATis ON, playback
will begin when you insert a tape,
even when the record tab is intact.
Details are on page 42.
Youmust connect the System to a
TV using the RF coaxial cable or
the audio/video cables in orderto
use the VCR features.These
hookups are explained on pages
eight and I l.
Youcannot use the VCRwhen the
System is inTuner made. If you fast
forward, rewind, or eject a videotape,
you may hear noise through the
speakers or some displaysmay be
incorrect.
Youcannot use the Tuner when the
System is in VCR mode. Make sure
you stop tape play before put_ng
the System in Tuner mode.