Table of Contents
Advertisement
Before
you call technical
support
If you have any problems using this DVD recorder, it may be caused by one of the following
reasons You can also call the customer service center in your country.
The telephone numbers can be found on the back of this manual.
Have the model number (MODEL NO) and the production number (PROD.NO) ready.
The serial number (PROD. NO.) is printed on the type plate fixed at the rear of the set.
PROBLEM
SOLUTION
The device
does not
react
to the touch
of a button,
the remote
control
is
working:
•/'Dealer Mode' is on: All buttons at the front of the DVD Recorder are locked
To switch off this function:
1
Disconnect the DVD Recorder from the power outlet.
2
Press and hold down • and OPEN/CLOSE--&
and re-connect the Recorder to
the power supply.
3
As soon as the time or '--:--' appears in the display (6 - l0 seconds), release • and
OPEN/CLOSE
_A
Resetting
the
DVD
Recorder
to default
factory
settings
,/VVarning:
All the information stored in the memory (programs, time, TIMER) will be reset (deleted)
1
Disconnect the DVD Recorder from the power outlet.
2
Press and hold down the STANDBY/ON
_ button on the front of the Recorder
while reconnecting to the power outlet.
3
Release STANDBY/ON_)when
'15 TY _,_4;v'appears in the display. All the
information stored in the memory (programs, time, TIMER) will be reset (cleared).
Read paragraph 'Initial installation'in 'Installing your DVD Recorder'.
76
Before you call technical support
Advertisement
Table of Contents
