Before You Call An Engineer - Philips DVDR75 Operating Instructions Manual

M
PROBLEM
If you have any problems using this DVD recorder, the reason may be one of the following. You
can also call the
The telephone numbers can be found on the back of this instruction manual.
Have the model number (MODEL NO) and the production number (PROD.NO) of your
recorder ready.
The serial number (PROD. NO.) is printed on the type plate at the back.
SOLUTION
b
Recorder in initial installation mode: Switch on the TV, switch over to the DVD recorder socket.
Now the menu for language selection should appear. Please read paragraph 'Initial Installation' in
the chapter 'Installing your DVD Recorder'.
b
'Dealer-Mode' is switched on: All buttons on the front of the set are locked.
Switch off the function:
1
Pull out the mains plug from the wall outlet.
2 Press and hold down h and OPEN/CLOSE J and put back the mains plug into the wall
outlet.
As soon as the time or '--:--' appears in the display (ca. 6 - 10 seconds), release h and
3
OPEN/CLOSE J .
b
There is no power supply: check the power supply
b
A programmed recording (Timer) is currently being made: If desired, cancel the programmed
recording (Timer) with STANDBY m .
b
There is a technical problem: disconnect from the mains power supply for 30 seconds, then
connect again.
If this doesn't help, you can reset your DVD recorder to the default factory settings.
b
All the information stored (TV channels, time and date, TIMER) will be lost.
1
Disconnect from the mains power supply.
2 Press and hold down the STANDBY/ON m button on the device and reconnect to the
mains power supply.
Release the STANDBY/ON m button when '
3
information stored (TV channels, time and date, TIMER) will be lost.
Please read paragraph 'Initial Installation' in the chapter 'Installing your DVD Recorder'.
b
Remote control not pointed toward the DVD recorder: Point the remote control at the machine.
See if the 'o(((' appears on the display briefly each time you press a remote control button. If it
does, the Recorder is receiving information from the remote correctly.
b
There is a technical problem: Take out the batteries, wait for 10 seconds and put them in again.
b
Batteries are flat: Change the batteries.
in your country.
' appears on the display. All the

Before you call an engineer