To Cancel A Cycle; Adding Dishware During A Cycle - KitchenAid KUDI220W Use And Care Manual

WASH SELECTION RINSE/DRY SELECTION
Rinse & Hold Cycle is used to rinse partial
loads of dishes until a full load is accumu-
lated_ No detergent is used. Dishware is kept
moist until a complete wash and dry cycle
can be run.
This cycle provides one rinse.
Important: All cycles may be used to wash
and dry dishwasher-safe china and crystal.
Check manufacturers" recommendations
RINSE& HOLD
CYCLE SEQUENCE
before washing.
TOTAL CYCLE
TIME (minutes)
13
WATER USED
)gallons)
2.25
Energy Saver Dry (no heat) can be used
with any Wash Selection to eliminate the
heat during the drying portion of a cycle. The
fan of the drying system will continue to
operate, helping the dishes to air dry
naturally. Under certain conditions, you may
find a few drops of water on the dishware
and silverware at the end of this cycle.
To Cancel A Cycle
The Cycle Selection Dial may be used to
cancel any cycle in progress. If water is
present in the dishwasher, turn the dial
slowly to the drain portion of the wash or
rinse. You will hear water draining when you
have advanced to the proper location. Let the
dishwasher drain completely. Lift the door
handle and advance the dial to the Pots/Pans
Cycle. This cancels the cycle.
If water is absent from the dishwasher, lift
door handle to stop dishwasher action.
Relatch door and advance dial to Pots/Pans
Cycle. This cancels the cycle.
TO STARTA NEW CYCLE -- Open dish-
washer; check detergent dispenser to be sure
it is properly filled. Close and latch door;
select the desired new cycle.
Adding Dishware During A Cycle
You can add a forgotten item to the dish-
washer anytime before the main detergent
wash portion of the cycle. To stop the cycle,
just unlatch the door handle. However,
opening the door during a cycle reduces the
cleaning power, so try to load all items before
starting the cycle.
TO RESTART DISHWASHER -- Close the door
and latch the handle, push cycle button
originally selected and if desired, the Energy
Saver button. The cycle will start exactly
where it was stopped.