Table of Contents
Advertisement
Grounding Instructions
For personal safety, the cooktop must be properly grounded. For maximum
safety, the power cord must be plugged into an electrical outlet that is
correctly polarized and properly g rounded.
DO NOT Operate the cooktop using a 2-prong adapter or an extension cord.
If a 2-prong wall receptacle is the only available outlet, it is the personal
responsibility of the consumer to have it replaced with a properly g rounded
3-prong wall receptacle installed by a qualified electrician.
See the INSTALLATION
INSTRUCTIONS packaged with this cooktop for
complete installation and grounding instructions.
Grounding type
wall receptacle
Do not, under any
circumstances,
cut, remove, or
bypass the
grounding prong.
Power supply cord with
3-prong grounding plug
This appliance is equipped with a 3-prong grounding
plug for your protection against shock hazard and should be plugged
directlyintoa properlygrounded
receptacle. DO NOTcutor removethe
grounding prong from this plug.
Avoid fire hazard or electrical shock.
DO NOT use an adapter plug, an extension cord, or
remove grounding prong from electrical power cord.
Failu re to follow this warning can cause serious injury,
fire or death.
Liquefied Petroleum (Propane) Gas Conversion
This appliance can be used with Natural Gas or Propane (L.P.) Gas.
It is shipped from the factory for use with Natural Gas.
If you wish to covert the appliance to LP Gas, use the supplied LP
Gas conversion kit and instructions, contained in an envelope
marked FOR LP/PROPANE GAS CONVERSION. The conversion
must be performed by a Sears or other qualified
LP service
dealer following
the supplied
instructions.
To avoid serious injury or death, any
additions, changes or conversions required for this
appliance to operate with either LP or Natural Gas
must be made bya Sears or other qualified LP service
dealer.
Before Setting Surface Controls
Locations
of the Gas Surface
Burners
The SIMMER burner is best used for simmering delicate sauces, etc. This
burner is located at the right rear burner position on the cooktop.
The STANDARD sized burners are used for most surface cooking needs.
These burners are located at the left front and left rear positions on the cooktop
(and there is one more standard burner located at the center rear position on
the 36" cooktop models).
The POWER burner is best used for bringing large quantities of liquid
rapidly up to temperature or when preparing larger quantities of food.
This burner is located at the right front position on the cooktop.
The BRIDGE burner is best suited when using rectangular or long
shaped cookware. The left rear and left middle are combined and
controlled by the same control knob. The left front burner may also be
added for a total of 3 burners.
Advertisement
Table of Contents
