Motor Safety Filter Changing; Exhaust Filter Changing - Kenmore 116.262212 Owner's Manual

w
WARNING
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the vacuum
cleaner without the motor safety filter,
Be sure the filter is dry and properly
installed to prevent motor failure and/or
electrical shock.
MOTOR SAFETY FILTER
ELECTROSTATIC
This filter must be replaced when dirty, It
should be replaced regularly depending on
use conditions, The filter CANNOT be
washed as it will lose its dust trapping
ability.
NOTE: See PARTS AND FEATURES for
Filter Number,
1. Remove the bag as outlined in the BAG
CHANGING section.
2. Lift the rubber
retainer and pull
out motor safety fil-
ter as shown.
retainer,
3. Repiace the fil-
ter, white side
out, by sliding it
back into place
under the ribs in
the bag cavity
Tuck filter in so
that it fits completely
under the rubber
4, Replace the bag as outlined in the BAG
CHANGING section,
,WARNING
Fire andtor Electrical Shock Hazard
Do not operate with a clogged exhaust
filter or without the exhaust filter or
exhaust filter cover installed.
,, ,, ,,,, ,,, ,, ,,,, , ,, , , ,,,,, ,,, , ,
EXHAUST FILTER
HEPA
The HEPA filter must be replaced when
dirty. Replace the filter when the entire sur-
face area is covered evenly, The filter
CANNOT be washed as it will lose its
dust trapping ability.
NOTE: See PARTS AND FEATURES for
Exhaust Filter Number
1, Pull out and up
on the exhaust fil-
ter cover to
remove from the
canister and lay
aside,
Exhaust_ X
FI/_r,_ - 2. When the
_ xhaust filter
becomes dirty,
remove it by pulling
straight up
Exhaust
Filter
\
3. Place the new
filter into the canister
with the foam seal
down°
15
Tab
(
"_ s/of
._ . Reinstall the
exhaust filter
___ cover by inserting
the tab into the
slot in the
canister, Press
_'"-_ 0 firmly to snap
exhaust filter
cover into place,