Panasonic TH-42LF25U Operating Instructions Manual page 44

Item
Off
Off: All the buttons on main unit can be used.
MENU&ENTER: Locks
On: Locks all the button on main unit.
Button lock
Sets Button lock with the unit buttons in the following procedure.
Off: Press
MENU&ENTER: Press
On: Press
Off
Off:
User1: You can only use
Remocon User level
User2: You can only use
User3: Locks all the buttons on remote control.
Enable:
Off-timer function Disable: Disables the "Off-timer function".
Note:
Normal
Sets the power mode of the unit for when the power recovers from failure or after plugging off and in again.
Normal: Power returns in as the same state as before the power interruption.
Initial Power Mode
Standby: Power returns in standby mode. (Power Indicator : red/orange)
On:
Note: When using multiple displays, "Standby" is preferred to be set in order to reduce a power load.
Off
You can set the power-on delay time of the displays to reduce the power load, when you press POWER button
to turn on the multiple displays that are set together, for example, on MULTI DISPLAY system.
Set each display's setting individually.
Off:
Power On Screen
1 to 30 (sec.): Set the power-on delay time (second).
Delay
Notes:
• During this function is working, the power indicator is blinking green.
• This function also works when the power recovers from failure or after plugging off and in again the power cord.
Off:
On:
The clock is displayed at the lower left of the screen when
Clock Display
Whether to show/hide No activity power off Precautions at the time of power ON is set.
Power On Message On:
(No activity power Off:
off) Note:
This setting is enabled only if "NO ACTIVITY POWER OFF" is "ENABLE" (see page 32).
Sets the lock setting for the display Power switch.
Power Switch Lock On:
Off:
Normalization
When both main unit buttons and remote control are disabled due to the "Button lock" or "Remocon User level" adjustments,
set all the values "Off" so that all the buttons are enabled again.
Press the button on main unit together with
"Shipping" menu is displayed and the lock is released when it disappears.
On MENU&ENTER
ENTER/
MENU
and
four times Press
ENTER/
four times Press
four times Press
User1 User2
You can use all of the buttons on the remote control.
, ,
button on the remote control.
Enables the "Off-timer function".
When "Disable" is set, the Off-timer is cancelled.
On Standby
Power returns in power On. (Power Indicator : green)
1 2 3.... 30
The display will be turned on at the same time as POWER button is pressed.
After pressing POWER button, the display will be powered on with time delay depending on this
setting.
Not display the clock.
Display the clock.
Note: When "PRESENT TIME SETUP" is not set, the clock is not displayed even
10:00
The warning precautions are shown at the time of power ON.
The warning precautions are not shown at the time of power ON.
Power switch operation is disabled.
Power switch operation is enabled.
button on the remote control and hold for more than 5 seconds. The
Adjustments
buttons on main unit.
INPUT
four times Press four times Press
four times Press
ENTER/
four times Press four times Press
User3
, , buttons on the remote control.
if "Clock Display" is "On" (see page 28)
Options Adjustments
ENTER/
INPUT
four times Press
ENTER/
button is pressed.
ENTER/
43