Winding The Bobbin From The Spool Holder; Threading - Pfaff 1540 Owner's Manual

Operate your Pfaff select
Winding the bobbin
from the spool holder
Place the sewing thread on the spool
holder (8). To guarantee free movement
of the thread and to give additional
hold to the thread spool, fit a spool cap
corresponding to the size of the thread
spool
Threading
Place the thread into guide A and pull it
through opening B and to the right under
the hook D. Wind the thread clockwise a
few times around in the bobbin.
Switch on the main switch
Hold the end of the thread firmly and
press the foot control. The winding action
will stop automatically as soon as the
bobbin is full. Cut the thread, push the
bobbin to the left and remove it.
Don't forget:
Turn the handwheel release disk (3) fully
back again. Then turn the handwheel (4)
towards you until it snaps into place.