Pfaff ClassicStyle 1525 Owner's Manual page 40

– –
ABC 5-
ABC 5-
1526/1536 – Standard buttonhole
• Insert the buttonhole foot and slide the
foot forward as far as it will go.
• Select stitch A. Sew the left side of the
buttonhole to the required length. Clip the
top thread after a few stitches.
• Select stitch B and sew a few bartacks
while holding the fabric securely.
• Select stitch C. Sew the right side of the
buttonhole until it matches the previous
side in length.
• Select stitch B and sew a few bartacks
while holding the fabric securely.
• Select stitch D. Secure the buttonhole by
sewing a few stitches.
• Carfully cut open your buttonhole.
Tip: For ne buttonholes, you can reduce the
buttonhole width with the stitch width dial
(27) down to approx. 3 mm. Use the center
needle position
2:10
–
3-5
h
3-5 0/1
3-5
0/1
.
Standard buttonhole with gimp thread
To sew especially durable buttonholes,
on heavy fabrics, knits or sportswear, we
recommend using a gimp thread.
On knits the gimp thread is particularly
important to prevent the buttonhole from
stretching.
• Lay the gimp thread over the rear
protrusion A and pass the thread ends
underneath the presser foot towards the
front.
• Clamp the threads to the left and right
of protrusion B.
• Slide the buttonhole runner as
far forwards as possible and sew the
buttonhole as described for your select
model.
• Pull the loop of the gimp thread into
the buttonhole and cut the threads.
A
Carfully cut open your buttonhole with scissors or
a seam ripper.
B