Adjusting The Buttonhole Seam Length With The Balance; Stretch Buttonholes/Cross Stitch Buttonholes - Pfaff creative 7570 Instruction Book

Adjusting the buttonhole seam length with the
balance
On highly slippery fabrics it may happen that the
stitch density of the left seam turns out differently
to that of the right seam. In this case, the seam
density can be adjusted using the balance.
The balance appears on the right in the display
and can be set with the cursor keys
"+—"
and
"—'
This procedure can, however, only be applied tot
semi-automatic buttonholes and engaged button
hole guide No. 10.
• Sew the first seam and the first bartack.
• While sewing the second seam adapt the
stitch density with the balance (in the plus-
section) to the first seam.
• Press key"
• Then press the "esc" key.
• Now program the buttonhole at the required
length.
• Confirm by pressing "o.k.".
Stretch buttonholes! Cross stitch buttonholes
Stretch buttonhole No. 41 and cross stitch button
hole No. 42 can
• be sewn fully automatically or
• by self-defining the length and stitch width of
the buttonhole (see standard buttonhole).
161
[7
The procedure for the self-definition of the second
bartack is the same as for the standard buttonhole.
Seam length and stitch density of the second
buttonhole seam can be set with the balance.
Important: Before you start the buttonhole, pull
buttonhole foot No. 5A to the front up to the
second red mark!
129
2; 3
4 5 6 7
8 9
C
0
.c
'C
0
C
0)
I
0
U,
U,
a,
0