Lamp Replacement Procedure - Optoma Projector User Manual

Appendices
The screws on the
™
lamp cover and the
lamp cannot be
removed.
The projector cannot
™
be turned on if the
lamp cover has not
been placed back on
the projector.
Do not touch the glass
™
area of the lamp. Hand
oil can cause the lamp
to shatter. Use a dry
cloth to clean the lamp
module if it was ac-
cidentally touched.

Lamp Replacement Procedure:

1. Switch off the power to the projector by pressing the " " button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Unscrew the two screws on the cover. 1
5. Lift up and remove the cover. 2
6. Unscrew the two screws on the lamp module. 3
7. Lift up the lamp handle and remove the lamp module slowly and carefully. 4
To replace the lamp module, reverse the previous steps.
8. Turn on the projector and use "Lamp Reset" after the lamp module is
replaced.
Lamp Reset: (i) Press "Menu"  (ii) Select "OPTIONS"  (iii) Select
56
English
"Lamp Settings"  (iv) Select "Lamp Reset"  (v) Select "Yes".
1
2
3
4