Table of Contents
Advertisement
/%
Storage
an d Maintenance
•
Vacations
If you will be gone for a month or less, leave the controls
at the usual settings.
Daring longer absences:
a) remove all food,
b) shut off the ice maker (if installed)
and the valve where
you tapped into the water line to supply the refrigerator,
c) disconnect
the refiigerator
from the electrical
outlet,
d) remove the filter catlddge
(certain
models)
and install
tile filter bypass
(see page 14 15). Dispose of the used
cartridge.
A new cartridge can be installed when the
refrigerator is put back m smwice,
e) clean and dry the ret?igerator thoroughly,
t) leave the doors open to prevent odors.
Moving
When moving,
follow steps a-f under Vacations.
In addi-
tion, remove
and carefully
pack any items that are easily
removable.
Ship the refrigerator
in an upright position with
the doors taped shut.
Replacing a Light Bulb
-_
C411TION:
Disconnect
the
power
cord
before
replacing
light
bulb(s).
Wear
gloves
as
)
protection
against
possible
broken
glass.
I
Always
use a standard
40 or 60 watt
appliance
bulb
when
replacing
a fresh
food
or freez-
er compartment
bulb.
Refrigerator
There are two light bulbs located at the top of the refriger-
ator compartment,
or_ the underside
of the Twin Fresh'"
control housing.
To replace a lightbulb(s), remove the control cover from
the control housing:
• grasp
the control
cover at the two [ear "finger tabs".
These
are located
at the upper
rear of the [resh food
compartment,
behind
the light shields.
• pull down slightly to clear the retainer tabs and slide the
cover forward
until it is free.
replace the bulb(s)
with a 60-watt,
standard
base appli-
ance bulb(s).
.
After replacing
the bulb(s), align the control cover on to
ihe ribs on the control ho/Jsing and slide it straight back
until it snaps onto the retainer
tabs.
On certain
models,
there is an additional
light
located
behind the top drawen
To replace:
• remove the top dlawer and cover as explained on page 10.
• carefully
reach
into the bulb cover
and unscrew
the
lightbulb.
• replace the bulb with a 60-watt
appliance
bulb.
Freezer
The freezer light is located on tile back wall of the freezer
compamnent.
To replace:
• unhook the tabs on the top of the light shield by press-
ing in with the thumb on the center top of the light shield
• pivot the shield down
• unscrew
the bulb when cool and replace
it with a stan-
dard 40-watt
appliance
bulb
• replace tbe bulb cover by pivoting it back into place a_ld
snapping
the tabs into the appropriate
slots•
Dispenser
Light
(dispenser
models
only)
To replace:
• Locate
the lightbulb
in the dispenser
area to the left of
the actuator•
• Unscrew
the used bulb and remove•
• Replace the bulb, using a 120V, 7-watt bulb.
Advertisement
Table of Contents
