Seal The Openings - Kenmore 362.6112 Series Use & Care Manual

A: Usage Situations where Appliance Power Cord
will be Disconnected Infrequently.
TEMPORARY METHOD
(Adapter plugs not permitted _,_
in Canada) )-_ I t_i -YI
Align large prongs/slots _ _-_-/ I I
\ _); " Ensure proper
\ /f | ground and firm
k_. [ j,) connection
FT_lr before use
An adapter may be used only on a 15-amp circuiL Do not
use an adapter on a 20-amp circuiL Where local codes
permit, a TEMPORARY CONNECTION may be made to
a properly grounded two-prong wail receptacle by the use
of a UL-listed adapter, available at most hardware stores
The larger slot in the adapter must be aligned with the
larger slot in the wall receptacle to provide proper polarity
in the connection of the power cord.
CA UTi 0 N:
Attaching the adapter ground
terminal to the wall receptacle cover screw does not
ground the appliance unless the cover screw is metal,
and not insulated, and the wall receptacle is grounded
through the house wiring, The customer should have
the circuit checked by a qualified electrician to make
sure the receptacle is properly grounded_
When disconnecting the power cord from the adapter,
always hold the adapter with one han& tf this is not
done, the adapter ground terminal is very likely to break
with repeated use.. Should this happen, DO NOT USE
the appliance until a proper ground has again been
established.
B: Usage Situations where Appliance Power Cord
will be Disconnected Frequently.
Do not use an adapter plug in these situations because
disconnecting of the power cord places undue strain
on the adapter and leads to eventual failure of the
adapter ground terminal. The customer should have the
two-prong wall receptacle replaced with a three-prong
(grounding) receptacle by a qualified electrician before
using the appliance_
The installation of appliances designed for mobile home
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280) or,
when such standard is not applicable, the Standard for
Manufactured Home Installations, latest edition
(Manufactured Home Sites, Communities and Set-Ups),
ANSI A2251, latest edition, or with local codes° In
Canada, mobile home installation must be in accordance
with the current CAN/CSA Z240/Mt! Mobile Home
Installation Code.
Electric Disconnect
Plug
This plug alIows you to conveniently disconnect the range
from electrical power..
1. Locate disconnect plug on the range back.
2. Pinch sides of connector and pull out of range back.
STEP 4
Seal the Openings
Seal any openings in the wall behind the range and in the
floor under the range when hookups are complete&
35