Fresh Food Storage - Frigidaire FRT18TPHW1 Important Safety Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Fresh Food Storage
continued)
Tilt-Out Crisper (some models)
Adjustable Humidity Control
slides up or down
Adjusting the ChilledAir Duct
J
Wine Rack
Crispers
The crispers, located under the bottom refrigerator shelf, are designed for storing
fruits, vegetables, and other fresh produce. Wash items in clear water and remove
excesswater before placing in the crispers, Items with strong odors or high moisture
should bewrapped before storing, Insome models, the crispers are drawers, in others,
they are tilt-out bins,
The Humidity Control (some models with Crisper drawers) allows you to adjust the
humidity within the Crisper, This can extend the life of fresh vegetables which keep
best in high humidity. Leafy vegetables, however, keep best when stored with the
Humidity Control set on HIGH, or in a drawer without a Humidity Control. This keeps
incoming air to a minimum and maintains maximum moisture content.
Crisper Cover Support (some models)
The Crisper Cover Support, located between the two
Crisper drawers, is shipped raised from the liner floor.
This prevents damage to the liner floor during shipping,
Once your refrigerator has been installed in it's final
location, the Foot of the Crisper Cover Support must
be lowered to prevent bowing in the middle of the
Crisper Cover, when food is placed on it.
Adjusting
the Foot of the Crisper Cover Support:
1, To lower the Foot, rotate in a clockwise direction
until it rests on the liner floor.
2, To raise the Foot, rotate in a counterclockwise
direction,
Foot
Crisper Cover Support
Dell Drawer
(some models)
Some models are equipped with a Dell Drawer for storage of luncheon meats,
spreads, cheeses, and other dell items,
Meat
Pan (some models)
Some models are equipped with a Meat Pan that can be positioned below any
refrigerator shelf. Use this pan for short term storage of bulk meat items. If meats are
to be kept longer than 1 or 2 days, they should be frozen.
Meat
Keeper
(some models)
The temperature in the Meat Keeper drawer can be made colder than the rest of the
refrigerator compartment by adjusting the Chilled Air Control. Meat will be partially
frozen, and may be kept fresh longer than if stored on a refrigerator shelf.
Before placing items in Meat Keeper, follow these steps to keep meat fresh.
1, Carefully handle meat with clean hands, and always keep compartment clean.
2, Store meat in its original wrapper, if necessary, overwrap in plastic wrap, or
foil to prevent drying. Wrap fish tightly to prevent odor trander to other foods.
3. If spoilage ever occurs, disinfect the compartment with liquid chlorine bleach
following label directions. Then, rinse with a solution of baking soda, and water.
Rinse with clear water, and dry.
The Chilled Air Duct can also switch sides, should you wish to move the split
cantilever shelf. To change sides:
• RemoveMeat Keeperdrawerandshelf.
Removescrew, Graspairduct, pushand
tip back to "unlock" it from the air outlet box.
• Move air duct to the other side, and push into place. Reinstall screw.
• Replace shelf and insert drawer.
Wine
Rack (some models)
The wine rack stores bottles of wine, or single 2diter plastic bottles of juice or
soda pop. To install, slide wine rack onto the shelf with the curve facing in.To
remove, slide wine rack out.install on either side of a SpillSate TM shelf,

Advertisement

Table of Contents
loading

Table of Contents