Frigidaire GLTF1670 Operating Instructions

OPERATINGINSTRUCTIONS
WASH/RINSE TEMPERATURE
WARM UA%M_
WARM
T_MPERATUP,_
COLD COLD
COLD COLD
WARM WARM /
COLD
COLD
HOT WARM COLD _/
EXTRA RINSE
YES NO
W_HQ
RINSE O
FINAL SPIN O
DOOR LOCK O
FINAL SPIN SPEED
SLOW NORMAL FAST
ON OFF
CYCLE SIGNAL
DELICATES
r_t,At
SM_,
FULL TQ_T,_T/
EXTRA CARE
WA5H
COLORS/
PERM PRESS
RNAL
SPIN
WASH
WHITES/
REGULAR
HEAVY WASH
WASH
UGHT
WASH
F_:AL
5PIN
SHORT WASH
Before Operating Your Washer
Read your washer Use and Care Guide. It has
important safety and warranty information. It also
has many suggestions for best washing results.
To reduce the risk of fire, electric shock,
or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS in your washer Use and Care Guide
before operating this appliance.
3. Pretreat stains and heavy soil.
........ lit ii r_l
Operating Steps
Read and follow Washing Procedures in your Use
and Care Guide. It provides detailed information for
preparing the wash load and choosing control
settings to ensure best washing results.
1. Sort laundry into loads that can be washed
together.
2. Prepare items for washing.
4. Add laundry load to the wash drum.
Printed in U. S. A.
5.
6.
7.
8.
9.
Open the dispenser drawer and add the
measured amount of detergent to the
detergent compartment. If desired, add liquid
bleach and fabric softener to the appropriate
compartments. Slowly close dispenser drawer.
The washer will not operate with the drawer
open.
Set Temperatures switch according to fabric
type and soil level of each load.
If desired, select Extra Rinse in Whites/Regular,
Colors/Perm Press, or Delieates cycle.
Select Final Spin Speed as desired.
Push in the cycle selector knob and turn it
clockwise to the desired wash cycle and
setting.
10. Start the washer by closing the door and
pulling out the cycle selector knob. The
washer will not operate with the door open.
As a safety measure, the door will
automatically lock during the entire wash
cycle. When the door is closed, the Door Lock
Indicator lights up when the washer starts, and
turns off at the end of the cycle.
To stop the washer, push in the cycle
selector knob.
To change a cycle, push in the cycle
selector knob and turn it clockwise to the
desired setting.
Pull out the knob to restart the washer.
11. Remove items when cycle ends. A signal
will sound at the end of the cycle when the
Cycle Signal ON is selected.
Note: From time to time you may see water in
the bleach and fabric softener compartments.
This is a result of the siphoning action and is
part of the normal operation of the washer.
p/N 134072300(0107)
t',,