Maintenance & Storage; Riding Attachments; Safety Signs - Exmark Lazer ZXS Operator's Manual

1.4.16 This mower was designed for one operator only. Keep all others away from
mower during operation.
1.4.17 Do Not mow with the discharge deflector raised, removed or altered unless there
is a grass collection system or mulch kit in place and working properly.
1.4.18 Be aware of the mower discharge and direct discharge away from others.
1.4.19 Do Not operate mower under the influence of alcohol or drugs.
1.4.20 Use care when approaching blind corners, shrubs, trees, or other objects that
may obscure vision.
1.5 MAINTENANCE AND STORAGE
1.5.1 For engine maintenance, follow the engine manufacturer's recommendations
precisely as stated in the engine manual.
1.5.2 Keep engine and engine area free from accumulation of grass, leaves, excessive
grease or oil, and other debris which can accumulate in these areas. These
materials can become combustible and may result in a fire.
1.5.3 Store fuel in a container specifically designed for this purpose. Store the fuel
container in a cool, dry place.
1.5.4 Keep the mower and fuel container in locked storage to prevent children from
playing or tampering with them.
1.5.5 Gasoline powered equipment or fuel containers should not be stored in a basement
or any enclosed area where open pilot lights or heat appliances are present.
1.5.6 Maximum mowing results and safety can only be achieved if the mower is
properly maintained and operated correctly.
1.5.7 Check all bolts frequently to maintain proper tightness.
1.5.8 Keep all guards, shields and all safety devices in place and in safe working
condition.
1.5.9 Frequently check for worn or damaged components that could create a hazard.
1.5.10 All replacement parts must be the same as or equivalent to the parts supplied as
original equipment.

1.6 RIDING ATTACHMENTS

Use only Exmark riding attachments. The use of other than Exmark riding attachments
may create a hazardous condition resulting in injury.

1.7 SAFETY SIGNS

1.7.1 Keep all safety signs legible. Remove all grease, dirt and debris from safety signs
and instructional labels.
1.7.2 Safety signs must be replaced if they are missing or illegible.
1.7.3 When new components are installed, be sure that current safety signs are affixed
to the replaced components.
1.7.4 New safety signs may be obtained from your authorized Exmark equipment
dealer or distributor or from Exmark Mfg. Co. Inc.
1.7.5 Safety signs can be affixed by peeling off the backing to expose the adhesive
surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.
1.7.6 Familiarize yourself with the following safety signs and instruction labels. They are
critical to the safe operation of your Exmark commercial mower.
- 6 -