Erasing Cd=Rw Cd's - Crosley Music Writer CR24-003A Instruction Manual

Manual Track Division Erasing a CD-RW
You can divide your recording into separate tracks
if you wish. By doing this, each song will have its
own sequential track number. To do this, you must
use the Split Track button (6/56).
While Recording your record, listen for the end of
each song. There will usually be a brief silence
between songs. Once you are at the end of the
song, press the Split Track button. The recording
will then go to the next track number by increments
of one. Once the recording is finished, you can press
the I_H (11/64) or the _ (8/52) buttons to go to
the beginning of each song.
If using a CD-RW, you can erase the whole CD and
rerecord it. Erase procedures are only possible with
CD-RW discs. It is not possible to erase or rerecord
a CD-R CD. To erase a CD-RW, follow the steps
below.
1
Press the FUNCTION button (2/68) to set the
unit to CD mode.
2
Load a recorded CD-RW into the unit.
3
Press the STOP button (12/53) to stop playback.
4
Press the ERASE button (3/57). ERASE / Y will
appear on the display ,Press PLAY Button(14/63)
to confirm and the erasing process will begin,if
cancel please press the STOP Button(12/53).
When finished, the display will first read "F Done"
and then "BLANK CD".
5 The CD is now ready to record.
NOTE: Once a CD is erased, the contents that were
on the CD cannot be retrieved.
12