Console Night Light - Kenmore 665.9214 Use & Care Manual

To Replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
To Install Starter and/or Bulb:
1. Fit starter prongs into starter mounting base and turn
clockwise.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
The console night light is located at the top of the Electronic
Oven Control panel. It has two replaceable parts. The fluorescent
light bulb is a standard F8T5 miniature fluorescent lamp. The
starter is the knob-shaped part to the left of the light bulb. It is a
standard FS-5C starter. The console night light will not work
during the self-cleaning cycle.
To turn on and off: Press the TOP pad.
To Remove Starter and/or Bulb:
1. Unplug range or disconnect power.
2. Push down with thumbs on the front of the lens cover while
pulling up with fingers on the back of the lens cover.
(
Push release lever toward bulb. The left end of the light
assembly will raise up.
1 2 3
1. Starter
2. ReleaseLever
3. Bulb
4. To remove starter, turn it counterclockwise and lift out of its
mounting base.
5. To remove bulb, roll it forward or backward 90 ° until it clicks,
then lift out.
2. Slide bulb prongs into bulb mounting base ends. Roll the bulb
forward or backward 90 ° until it clicks.
Push down on the left end of the bulb mounting base. When
the assembly latches, it will click.
...... ........... i:: . .......
Replace lens cover. Position the two rear lens cover tabs in
front of the two metal spring clips (located directly behind the
bulb). Push back and down on the lens cover to lock into
position.
-. ?_¢:*
5. Plug in range or reconnect power.
©eel
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
Before Removing:
1. Use a putty knife or screwdriver and insert it at the bottom
corner of the door stop clip.
1. Door Stop Clip
2. Pry door stop clip free and remove from front frame hinge
slot. Take care not to scratch finish.
3. Repeat procedure for other door stop clip.
25