Cooktop Lockout; Electronic Oven Control; Display; Start - Kenmore 665.9214 Use & Care Manual

ELECTRONIC OVEN CONTROL
................. MEATS/ SLOW
........................... P_I,_Y COOKER_.__
COOEJES PIZZA
/
8
2 3 4 5 6 7
\/
lO
11 12 13 14
q
15 16
!. RECIPERECALL
TM
2. Slow Cooker
3. Display
4. Add I Minute
5. Timer
6. Cooktop Lockout
Cooktop Light (onsome models)
7. Oven Light/Oven Lockout
8. Oven Selectors
(SERVE WARM - on some models)
9. Self-Clean
SENS-A-CLEAN
TM
(on some models)
LOGI-CLEAN
TM
(on some models)
SELECT CLEAN
TM
(on some models)
10. Temperature Setting
11. Timed Cooking
12. Clock
!3. Hour
14. Minute
15. Start
16. Stop/Clear
When power is first supplied to the appliance, make sure the
surface burners are in the OFF position. Everything on the display
will light up for 5 seconds. Then the time, "PF" will appear on the
display.
If "PF" appears at any other time, a power failure has occurred.
To remove "PF" and to reset the clock, press STOP/CLEAR.
When the oven is in use, this display shows time, temperature
and what command pads have been pressed.
When the oven is not in use, the display will show the time of day.
The START pad begins any function. If not touched after touching
a pad, "START?" will appear in the display.
If cooking is interrupted, touching START will resume the preset
cycle.
The STOP/CLEAR pad stops any oven function except for the
Clock, Timer and Cooktop or Oven Lockouts.
After pressing STOP/CLEAR, the display will show the time of
day or, if the minute timer is also being used, the time remaining.
Add I ,ute
Cook time may be added in 1-minute increments, up to
99 minutes, by touching the ADD 1 MIN pad.
Touching ADD 1 MIN during a cook cycle will add 1 minute of
cook time.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
1. Press CLOCK.
2. Press the HOUR/MIN "up" or "down" arrow pads until the
correct time of day shows on the display.
Press CLOCK or START.
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheating, or has been preheated
• Function has been entered
Three tones
• Invalid pad press
11